ASI 0042 | ASI 9" Surface Mounted Single Jumbo Roll Round Toilet Paper Dispenser
American Specialty Surface Mounted Jumbo - Roll Toilet Paper Dispenser: shall hold one (1) roll up to 10?? dia with 1-5/8?? dia. core or 2-1/4?? dia. core.
- Cover shall be fabricated of alloy 18-8 stainless steel, type 304, 20 gauge with a No 4 satin finish.
- Rear of cabinet shall have five (5) mounting holes to suit #8 or #10 flat head screws.
- Cover shall be of one piece construction hung on stainless steel pin hinges and shall be held closed by a tumbler lock keyed to other ASI washroom equipment with key provided.
- A viewing slot with clear plastic window shall be provided.
- Unit shall accommodate smaller core size roll by removing the rubber core adapter “O” rings.
- Opening on bottom of cabinet shall have stainless steel teeth for toilet tissue tearing on both sides.
- Cover at top shall have shoulder pin to interlock back plate when closed.
- Overall Size: 10 5/8" x 4 1/2"

Installation:
For general utility surface mount unit within 12?? of front of toilet from center line and 31?? above finished floor (AFF) from bottom of unit with five (5) screws (by others) through mounting holes provided.
For compliance with ADA Accessibility Guidelines install unit so that leading edge of roll is no farther than 36?? (914mm) from back wall behind commode and centerline of roll is 19?? minimum above finished floor (AFF) to 44?? max. AFF.

Operation:
One (1) 10?? (254mm) OD jumbo roll of toilet paper is mounted over 2-1/4?? ID core adapter. One (1) 1-5/8?? ID core roll may be used by removing the rubber core adapter rings.
Viewing slot continuously reveals tissue level. Key locked cover prevents unauthorized access or removal. Roll is replaced on a cycle determined by maintenance needs.