ASI 130 | ASI Security Recessed Shelf- Chase Mount
American Specialty Security Recessed Shelf- Chase Mount: shall be fabricated of 18-8 alloy stainless steel, type 304, No 16 gauge.
- All exposed surfaces shall have No 4 satin finish.
- Interior shall be 4" (102mm) deep and shall have glass blasted satin matte finish.
- All corners shall be welded and ground smooth.
- Back of shelf shall be provided with four (4) welded-on anchor nuts that accept threaded studs (supplied).
- Back plate shall be fabricated of die-formed galvanized steel No 11 gauge and shall be reversible for shallow or deep wall installation.
- Back plate shall be provided with four (4) welded-on threaded posts to receive threaded rods of length specified at time of order and shall be equipped with four (4) washers and nuts.
- Wall Opening: 16 1/2" x 5 1/2"

Installation:
For compliance with ADA Accessibility Guidelines, install unit so that shelf top is between 48" (1219mm) maximum above finished floor (AFF) and 32" (813mm) minimum AFF. For general utility mount unit 42" (1067mm) AFF or 18" (457mm) above wash basin.
Mount unit through wall opening and secure to finished wall by adjusting threaded rods (supplied) to accommodate wall thickness. The length of the threaded rods is determined by the thickness of the wall on which the shelf is mounted. Specify the thickness of the wall in the following increments (e.g. 130- LT4).
Rough wall opening (RWO) required is 5-1/2" x 16-1/2"